3D model
Built from overlapping photos. Orbit it, walk through the rows in first person, or replay the flight from the drone with each photo shown in place.
Overview
What the flight found, in plain language. Each finding links to where it is.
What this flight found
One 8-minute flight, processed in minutes. Every finding below links to where it is, the photos that show it, and the numbers behind it.
From the drone
See all photos ↓Map
Switch layers, drag the divider to compare two layers, measure, and click any spot to see every photo that captured it.
Trees
Every tree measured: height, crown, canopy volume and health compared with the rest of the block. Click a dot or a row.
Height vs chlorophyll
Each dot is a tree. Low and to the left: small and pale, so check first. Click a dot.
| Tree | Status | Height m | Crown m | Volume m³ | NDVI | NDRE | vs block |
|---|
Photos
All the drone's photos. Sharp previews are included for the processed strip; the rest show the camera's built-in thumbnail. Click any photo to open it, then use ← → to browse.
Flight replay
Step through every photo in order with the drone position and telemetry. Press Play, drag the slider, or use the arrow keys.
Every photo the drone took, in order. Sharp, full-resolution previews are included for the processed strip; the rest show the camera's embedded thumbnail.
Where the drone was
Telemetry at this photo
Along the flight
Altitude (teal), ground speed (blue) and airframe tilt (amber). Tilt while holding a steady speed is what reveals the wind. Click the chart to jump.
Data quality
How good the capture was, and the conditions during the flight.
Checks
Capture quality
Conditions in flight
3D model
Stereo depth from consecutive photos, scaled by the RTK baseline and merged across pairs. Good for heights and volumes to roughly 10–20 cm; use a full photogrammetry run for survey deliverables.